Siemens REV24-RF 7-Day Wireless Programmable Thermostat
Replaces obsolete REV23-RF
The new REV24RF digital room thermostat from Siemens are designed for straightforward operation and a high level of reliability. Improved design ensures that the new products are even more user-friendly and - thanks to very accurate room temperature control - offer enhanced comfort while providing even greater energy efficiency. The new thermostats from Siemens are suited for any type of heating application and excel in a very good price-performance ratio.
User-friendly features include:
* Program selection slider
* Extremely bright high-contrast backlit display
* Bi-directional commumication with receiver
* 7-Day programming
* Over-ride functions
* Holiday mode
* Party mode
* Frost and overheating protetion
* Information level for checking settings
* Sensor calibration
* Can be used for heating or cooling
* Pump/valve protection
* Optimum Start
* Manual over-ride button on receiver
* Automatic Summer/Winter time change
* Thermostat can be wall mounted or used with supplied table stand
* Supplied complete with receiver
* 16(2)A SPDT Volt-Free contacts
Dimensions:
Transmitter: 94x135x30mm HxWxD
Receiver: 88x114x32mm HxWxD
Model: REV24RF/SET
Ask a Question about Siemens REV24-RF 7-Day Wireless Programmable Thermostat
-
It would need to be installed on the wall next to the boiler. An electrician would be able to fit it.
-
It will replace it using the existing wires and has the same terminal numbers. As the backplate is part of the receiver, you will need to replace the backplate.
-
You will need to replace the receiver as well. The more expensive makes, like Siemens, are the better ones.
-
The switching differential in 2-point mode is adjustable (0.5C default).
However I would recommend PID self learning mode for increased comfort and fuel savings.
-
You can have up to 3 comfort periods per day.
-
You will need to change the receiver, but it will connect to the same 4 wires.
-
Hi. Yes it would. It will connect to the same 4 wires as the RDJ10-RF.
-
Assuming you have the RT500-RF, then yes the receiver will connect to the same 4 wires as the Salus receiver.
-
This will not control hot water, so if your hot water is timed you will need to retain the programmer for that.
-
No you can bind it into work with your existing receiver.
-
Yes, the Siemens receiver will connect to the same 4 wires as the Honeywell receiver.
-
I would recommend enabling the optimum start via the DIP switched. The manual for more information.
-
The is a reset button under the DIP switch panel on the back of the unit. If that doesn't work, then a new unit will be needed.
